modEl h8245
doUblE mini on/off
sWitCh
instrUCtions
For questions or help with this product contact Tech Support at (570) 546-9663 or [email protected]
to reduce risk of serious burns, electrocu-
tion or death when installing this switch:
• only use this switch to replace an exist-
ing component switch that has the same
physical configuration and equivalent
electrical specifications/ratings.
figure 1. Model h8245 on/oFF switch.
• Installation must only be performed by an
introduction
the Model h8245 features two on/oFF toggle
switches in one assembly that operates two
electrician or qualified service personnel,
and all applicable electrical codes must
be adhered to.
3
separate circuits. this assembly fits into a ⁄4" x
7
• Turn off and completely disconnect all
power sources to the component before
installing the switch.
⁄
8" rectangular hole.
specifications
rated Voltage.....................................125V/250V
rated Current at 125V................................... 10A
rated Current at 250V.....................................6A
• Only install this switch on the "hot" wires.
do not install it on the neutral or ground
wires. otherwise, the component could
still be receiving live current even when
the switch is turned OFF.
• Do not use this switch in wet or damp
locations, or near explosive fumes or
flammable liquids. it is not sealed or rated
for these environments.
• Make sure there is a verified compo-
nent ground on the circuit this switch is
installed.
Copyright © ApriL, 2011 By grizzLy industriAL, inC.
Warning: no portion of this instrUCtion shEEt may bE rEprodUCEd in any shapE
or form WithoUt thE WrittEn approval of grizzly indUstrial, inC.
#ts13933 printed in ChinA
|