Metra Electronics Car Stereo System 99 1005 User Manual

INSTALLATION INSTRUCTIONS FOR PART 99-1005  
APPLICATIONS  
KIA Sedona 2002-2005  
KIA Spectra 2002-2004  
(2004 Base and LS models only)  
99-1005  
KIT FEATURES  
• DIN Radio with Pocket Provision  
• ISO Mount Radio with Pocket Provision  
KIT COMPONENTS  
A) Radio Housing • B) ISO Snap In Brackets • C) Trim Plate • D) (4) Phillips Pan Head Screws  
• E) Rear Support Bracket • F) Pocket  
C
F
B
D
A
E
TOOLS REQUIRED:  
• Phillips Screwdriver  
1-800-221-0932  
© COPYRIGHT 2004 METRA ELECTRONICS CORPORATION  
 
99-1005 DASH DISASSEMBLY  
KIA SEDONA 2002-2005  
A
1
2
3
4
5
Disconnect the negative battery-  
terminal to prevent an accidental  
short circuit.  
Remove the ashtray and (1) Phillips  
screw exposed in the ashtray cavity.  
(Figure A)  
Unclip and remove the small trim  
panel from around radio, climate con-  
trols and shifter. (Figure A)  
Remove (4) Phillips screws from the  
radio trim panel then unclip and  
remove the panel. (Figure B)  
B
Remove (4) Phillips screws securing  
radio. Unplug and remove radio.  
(Figure C)  
Continue to kit assembly.  
C
1
 
99-1005 DASH DISASSEMBLY  
KIA SPECTRA 2002-2004  
(2004 Base and LS models only)  
*Note: Refer also to the instructions included with the aftermarket radio.  
A
1
2
Disconnect the negative battery-  
terminal to prevent an accidental  
short circuit.  
Remove (2) Phillips facing up above  
gauge cluster. (Figure A)  
3
Unsnap and remove top portion of  
steering wheel column cover. (Figure B)  
4
Unsnap and remove entire panel from  
left side of steering wheel to right side  
surrounding radio. (Figure C)  
B
5
Remove (4) Phillips screws securing  
radio. (Figure D)  
Continue to kit assembly.  
D
C
2
 
99-1005 KIT ASSEMBLY  
DIN RADIO WITH POCKET PROVISION  
*Note: Refer also to the instructions included with the aftermarket radio.  
A
1
2
Mount the pocket to the back of the  
radio housing using (2) of the screws  
supplied with the kit. (Figure A)  
Mount the rear support bracket to the  
back of the pocket using the remaining  
(2) screws supplied with the kit.  
(Figure A)  
• Spectra only skip to final assembly.  
3
Slide the DIN cage into the Radio  
Housing and secure by bending the  
metal locking tabs outward. (Figure B)  
B
4
Slide the aftermarket radio into the  
cage until it snaps into place. (Figure C)  
Continue to final assembly.  
C
3
 
99-1005 KIT ASSEMBLY  
ISO MOUNT RADIO WITH POCKET PROVISION  
*Note: Refer also to the instructions included with the aftermarket radio.  
A
Mount the pocket to the back of the  
radio housing using (2) of the screws  
1
supplied with the kit. (Figure A)  
2
Mount the rear support bracket to  
the back of the pocket using the  
remaining (2) screws supplied with  
the kit. (Figure A)  
3
Mount the ISO Brackets to the after-  
market radio using the screws sup-  
plied with the radio. (Figure B)  
B
4
5
Slide the radio into the radio open-  
ing until the side clips snap into  
place. (Figure C)  
Snap the trim plate onto the front of  
the Radio Housing. (Figure D)  
Continue to final assembly.  
Note:  
To remove the radio from the  
radio housing, unclip and remove  
ISO trim-plate. Then use a small  
flat blade screw driver to release  
the ISO snap in brackets and slide  
the radio out of the radio housing.  
C
D
4
 
99-1005 FINAL ASSEMBLY  
FINAL ASSEMBLY  
(
A) Strip wire ends back 1/2"  
B) Twist ends together  
C) Solder  
D) Tape  
Locate the factory wiring harness in the dash. Metra recommends using the  
proper mating adapter and making connections as shown. (Isolate and individ-  
ually tape off the ends of any unused wires to prevent electrical short circuit.)  
1
2
3
Re-connect the negative battery terminal and test the unit for proper operation.  
(All Sedona and Spectra ISO mount radio only) Reassemble radio and dash  
assemblies in reverse order of disassembly.  
(Spectra DIN radio only) Place assembled kit into the radio cavity in the dash, do  
not bolt in.  
(Spectra DIN radio only) Snap the dash panel back into place over the dash.  
Pressure fit the kit between the dash and the dash panel.  
4
5
(Spectra DIN radio only) Slide the DIN cage into the radio opening in the dash  
panel and radio housing. Secure the cage by bending the metal locking tabs  
outward.  
6
(Spectra DIN radio only) Slide the aftermarket radio into the cage until it snaps  
into place.  
FINAL WIRING CONNECTIONS  
Make wiring connections using the EIA color code chart shown below and the instructions included with the  
head unit. Metra recommends making connections as shown below; Strip, Splice, Solder, Tape. Isolate and  
individually tape off ends of any unused wires to prevent electrical short circuit.  
METRA / EIA WIRING CODE  
12V Ignition / Acc. . . . . . . . . . Red  
Right Front (+) . . . . . . . . . . . . Gray  
12V Batt / Memory. . . . . . . . . Yellow  
Ground. . . . . . . . . . . . . . . . . . Black*  
Power Antenna. . . . . . . . . . . . Blue  
Right Front (-). . . . . . . . . . . . . Gray/ Black  
Left Front (+) . . . . . . . . . . . . . White  
Left Front (-). . . . . . . . . . . . . . White / Black  
Right Rear (+) . . . . . . . . . . . . Violet  
Amp Turn-On . . . . . . . . . . . . . Blue / White  
Amp Ground. . . . . . . . . . . . . . Black / White  
Illumination . . . . . . . . . . . . . . Orange  
Dimmer . . . . . . . . . . . . . . . . . Orange / White  
Right Rear (-) . . . . . . . . . . . . . Violet / Black  
Left Rear (+) . . . . . . . . . . . . . Green  
Left Rear (-) . . . . . . . . . . . . . . Green / Black  
*NOTE: When a Black wire is not present, ground radio to vehicle chassis.  
All colors may not be present on all leads due to manufacturer’s specifications.  
5
 
99-1005 INSTRUCTIONS  
1-800-221-0932  
REV. 11/09/06 © COPYRIGHT 2004 METRA ELECTRONICS CORPORATION  
INST99-1005  
 

KTI Networks Switch KSD 541 User Manual
Lantronix Network Router 900 422 User Manual
Legacy Car Audio Car Amplifier LA 1099 User Manual
Lennox Hearth Log Splitter LSVFSD 18 User Manual
Life Fitness Treadmill M051 00K60 B098 User Manual
Lightolier Work Light C7E17VM User Manual
Lindy Network Card 51135 User Manual
Lochinvar Water Heater IB IW 1500 User Manual
Metz Flat Panel Television 42TM92 User Manual
MGE UPS Systems Power Supply 2000 RT 2U User Manual