WMSTR-WR-P01, WMSTR-WR-P02
• ADM loop technology with
System Sensor/200 protocol
• Long lifetime of strobe due to the use
of LEDs
• Low power consumption
• Versions with or without integrated
dual-isolator available
• Various base types available –
IP24, IP44, IP65
Description
The loop powered strobe is fitted into a round, red plas- ting. For this purpose a special base is needed. Various
tic case. It is powered and actuated as a module via the base types for protection classes IP24, IP44 or IP65
ADM loop with System Sensor/200 protocol.
are available, depending on the application. An optional
mounting plate can be supplied for surface mounted
The address of the strobe is selected with two decadic cabling.
rotary switches located at the bottom of the device.
The strobe is available in two different versions: With or
The strobe is designed for indoor or outdoor wall moun- without integrated dual-isolator module.
Specifications
Operating voltage
Flash frequency
Ambient temperature
Dimensions ø × H
Weight
Supply through loop voltage
1Hz
-25°C to +70°C
112 × 37 (mm) (incl. base LPBW)
80g
red
Colour
Building Safety. Building Security.
A
© LABOR STRAUSS SICHERUNGSANLAGENBAU GMBH • A-1231 WIEN • WIEGELESTRASSE 36 • TEL +43 1 52114-0 • FAX +43 1 52114-27
WMSTR-WR-P0x_DBL_LST_EN_0804.PDF • PAGE 1
[email protected] • WWW.LST.AT • ALL RIGHTS RESERVED
|