JVC Home Security System LST0723 001A User Manual

Changes in mounting the camera  
The ceiling mount bracket comes attached to the camera unit. Before  
installing, unfasten the ceiling mount bracket from the camera unit.  
Precautions during transportation  
When mounting ceiling mount bracket to the camera unit during  
transportation, let out the tip of fall prevention wire so that it is not caught.  
If the fall prevention wire is caught in the gap of ceiling mount bracket, the  
ceiling mount bracket might not be able to detached from the camera unit.  
A Check to ensure that the camera fixing lock knobs (x2) is not turned on.  
If it is locked, slide the camera fixing lock knobs to unlock in the  
direction as shown below.  
B Push in the camera fixing lock knobs (x2) from both left and right sides  
in the direction as illustrated in the diagram.  
Unfasten the ceiling mount bracket on a table to prevent it from falling off.  
Memo  
If it is difficult to push in the camera fixing lock knob, push in while  
pressing the edge of camera (figure A) against the table where the  
process is being carried out.  
C Lift the camera unit upward to remove the ceiling mount bracket, and  
pull down in the direction as indicated.  
A
Let out the tip of fall prevention  
wire  
A
Camera fixing lock  
knob (x2)  
B
B
C
Ceiling mount bracket  
Camera unit  
© 2008 Victor Company of Japan, Limited  
LST0723-001A  
 

Indesit Cooktop PI 604GB User Manual
JL Audio Automobile Accessories SB GM VETC6 10W3V2 User Manual
Jwin Digital Photo Frame JP 147 User Manual
Kenmore Range 790754 User Manual
Kenwood Blender SB250 User Manual
Kenwood DVD Player DVF R5060 User Manual
Keys Fitness Bicycle 550 Upright User Manual
KitchenAid Waffle Iron KPWB100 User Manual
Konica Minolta Oxygen Equipment PULSOX 300 User Manual
Kramer Electronics Welder SG 6 User Manual